Mumbai: The main runway of the Mumbai airport was shut for about 40 minutes on Sunday after pilots observed low friction levels due to rubber deposits on the surface. The deposits had to be removed on a war footing to avoid skidding of aircraft. Operations were shifted to the secondary runway, which along with poor visibility and winds led to some flight delays.
An airport spokesperson said that the main runway remained unavailable between 3.43 p.m. and 4.17 p.m. during which flights were routed to the secondary runway. During this period, a Jet Airways flight from Dhaka carried out a go-around (aborted landing at the last minute) twice. A Kozikode-Mumbai Jet Airways flight also carried out a go-around.
Officials said that the greater the accumulation of materials is, the lower the friction levels. Each time an aircraft lands, its tires deposit approximately 1 to 1.5 pounds (454g) of rubber onto the surface. The build-up of these heavy deposits can over time, if not treated properly, reduce the friction levels of the surface, potentially causing the aircraft to lose braking capabilities and directional control.
As per requirements of aviation regulator, Directorate General of Civil Aviation, runways should be periodically cleaned of rubber deposits to regain friction. “Cleaning of rubber deposits at the touch down zone on the runway will increase the friction levels. This procedure is strictly followed and the friction coefficient given to the crew during adverse weather conditions, as a part of the standard practice,” an airport official said.
24/06/18 aditya anand/The Hindu
To Read the News in full at Source, Click the Headline
An airport spokesperson said that the main runway remained unavailable between 3.43 p.m. and 4.17 p.m. during which flights were routed to the secondary runway. During this period, a Jet Airways flight from Dhaka carried out a go-around (aborted landing at the last minute) twice. A Kozikode-Mumbai Jet Airways flight also carried out a go-around.
Officials said that the greater the accumulation of materials is, the lower the friction levels. Each time an aircraft lands, its tires deposit approximately 1 to 1.5 pounds (454g) of rubber onto the surface. The build-up of these heavy deposits can over time, if not treated properly, reduce the friction levels of the surface, potentially causing the aircraft to lose braking capabilities and directional control.
As per requirements of aviation regulator, Directorate General of Civil Aviation, runways should be periodically cleaned of rubber deposits to regain friction. “Cleaning of rubber deposits at the touch down zone on the runway will increase the friction levels. This procedure is strictly followed and the friction coefficient given to the crew during adverse weather conditions, as a part of the standard practice,” an airport official said.
24/06/18 aditya anand/The Hindu
0 comments:
Post a Comment